The goal of the HV connections on all hybrids is 
to take HV+ and HV- which come in through the cable and 
connect HV+ to the z side finger pad and to connect HV- 
to the phi side finger pad.  Both HV+ and HV- go through 
a low-pass filter made up of a 10K resistor and a 0.022uF 
capacitor.  
	When HV+ arrives at the hybrid through the cable,
it is connected inside the hybrid to the HV jumper trace
along the right side of the hybrid, as well as to the pad
marked HV+ on the diagrams.  HV- is connected inside the
hybrid to the pad marked HV- on the diagrams.  HV- is also
connected to a trace along the left side of the hybrid in
line with the jumper trace on the right side.  This trace
is covered with dialectric, but when composite hybrids are
fabricated (a 5-chip hybrid for example), this trace connects
HV+ on the left 2-chip hybrid to HV- on the right 3-chip 
hybrid.
	The diagrams shown are assuming that the 7-chip
hybrid has the cable connected in the middle, the 6-chip
hybrid has the cable connected on the right side, and the
5-chip hybrid has the cable connected on the left side.